Universeal Stone Foam colour enhancer penetrating foam is a low V.O.C. waterbased natural stone colour enhancer that seals and penetrates grout, stone and masonry surfaces to protect against oil and water-based stains. The no mess foam formula clings to vertical surfaces providing accurate, non-streak coverage.
Universeal Stone Foam can be applied indoors or outdoors to cured grout, masonry, quarry, saltillo, slate, terracotta, sandstone, brick and precast stone. [Data Sheet]
Coverage per 442ml: Square metres: 5 - 14m2
Coverage will vary depending on the type of surface application.
Directions for use:
1. Make sure that the surface is dry, thoroughly clean and free from waxes, sealants, or coatings of any kind.
2. Shake can well. Point valve opening towards surface to be sprayed, holding about 6-10 inches away. Spray on a fine mist and let stand for a few minutes. Using a clean, dry cloth or sponge, wipe into stone. Repeat if necessary to attain desired look.
3. Allow to cure for 24 hours. Test area after application using water droplets, if droplets are absorbed, a second or third coat may be necessary to attain the desired performance.
Surfaces which are not to be sealed must be protected with masking material. Always test product in an inconspicuous area to determine suitability for intended use.
Up to 15 years. This will vary depending on the type of surface, wear and proper maintenance. This is not a warranty.
Clean treated areas with Universeal Easy Clean, do not use harsh or abrasive cleaning agents as this can have a negative effect on the treated surface.