Universeal One-Coat MicroSeal is an innovative water based impregnator developed to eliminate the need for more than one coat application to porous natural stone surfaces.
Universeal One-Coat MicroSeal is suitable for use with all types of porous stone surfaces. Its excellent penetration properties will not leave any film residue, whilst leaving the stone’s colour and tonality natural with a matt finish. Universeal One-Coat MicroSeal is a safe, non-flammable, earth friendly biodegradable formula.
Up to 15m2 per litre.
Depending on texture and porosity of surface.
Directions for use:
1. Make sure surface area is completely clean and dry before application.
2. Shake product well and apply the sealer generously until saturation of the stone surface. Allow the sealer to stay wet and in contact with the stone surface for at least 5 minutes. The sealer can be applied with a low pressure sprayer, natural fibre brush, roller, sponge or paint pad.
3. After approximately 20-30 minutes of application, remove any sealer visible on the surface by wiping completely dry with absorbent cloth or towel. If any sealer residue is left on the stone surface wipe clean with a cloth dampened with the sealer.
4. Always allow a minimum of 8 hours drying time before the commencement of grouting, it is recommended that a small test area is done first to check against staining especially when using coloured or polymer modified grouts. In cases with very porous stone it may be necessary to apply more than one application to achieve the desired effect.
Not applying sealer correctly to saturation of stone may result in inadequate stain protection. Always try product in an inconspicuous area prior to use.
Under typical conditions the effect of the impregnation can be considered to have an effect for up to 10 years.
Effectiveness and longevity is reliant on initial thorough application, foot traffic and the use of correct maintenance cleaning products.